What are old records made of?

Wish you were here

Label of an acetate record. The hole in the center, like a vinyl record is for the turntable spindle, but the hole on the side is for holding the record during the recording process.

Acetate records are usually 7″, 10″ and 12″ in diameter. They are the ones currently sold, although during their history there have been from 5″ to 21″ microphones used for old sound systems (the first ones) for sound film. They are usually made of aluminum (inside), with a thin coating of shellac or nitrocellulose acetate. This smooth plastic coating is cut by a stylus. Some discs already have a groove as a guide for the stylus, but most do not. The operation of these discs is the same as that of vinyl records, but the difference is that these discs are recordable. Nowadays the recording duration on a dubplate is almost similar to that of a vinyl record, although there are also dubplates with the original quality. Depending on the equipment used, a dubplate can be destroyed in 20 plays or last a lifetime.

What are the old records called?

Acetate discs are usually 7″, 10″ and 12″ in diameter. They are the ones currently sold, although during their history there have been from 5″ to 21″ microphones used for old sound systems (the first ones) for sound films.

How to recognize an original vinyl record?

“A dull disc is synonymous with a reeled disc,” he tells. If you hold the record up to the light, you will easily notice the bluish gleam of a well-maintained record. The same is true if you run your finger along the grooves and notice some strange relief, perhaps less noticeable to the naked eye.

Read more  Are there piranhas in Montana?

What material was used before vinyl records?

The phonograph used a piece, called a cylinder, to record and reproduce sounds. These were first made of tin-coated cardboard, then of waxed cardboard and finally of solid wax, which offered higher quality and durability.

The beatles

Shellac records are much less durable than the younger generation of vinyl, so many of the surviving 78s tend to be rare and their playback quality diminishes greatly over time.

These recordings are often called “LPs” or “LP records”, short for “Long Play”, as the slower playback speed and narrow grooves allowed the 33 rpm records to store more audio than their older varieties.

Although less common, some vinyl records of the 1960s and 1970s were made with extremely narrow grooves and played at very slow speeds for maximum recording length.

Shellac is more brittle than vinyl, so these older records are more fragile. Dust in the grooves could also compromise audio quality, producing more crackling and popping when they come in contact with the stylus.

What were the disks like?

The standard format for several decades was the 10-inch, 78-rotation-per-minute shellac disc, used by artists and orchestras to record their work and bring it into people’s homes for the first time. … The recording process was quite rudimentary and was called acoustic recording.

What are the large discs called?

Acetate discs

Acetates are a type of phonograph records used during the 1930s to 1950s to record and broadcast music.

How to know the price of vinyl records?

The free Discogs app allows you to keep track of your collection, add music to your wish list, and easily scan an item to find the vinyl value and other information in the database. The app is currently available on Android and iOS.

Record player

Invented by Emile Berlirner, the gramophone or jukebox was the most widely used sound recording and reproduction device from the end of the 20th century until the middle of the 21st century. The secret of its success was that at that time it presented a series of improvements with respect to its predecessor, Thomas Edison’s phonograph, mainly its capacity to make mass productions, using a flat disc (slate) instead of a cylinder.

Read more  What is the most common fish in Kansas?

The gramophone had a rotating plate that turned this (slate) disc which, with the help of a needle supported by an arm that sat on the disc and traveled through its grooves, and that of a membrane, transformed the vibrations into a sound that was reproduced through its trumpet. The plate worked by turning a crank located on one side of the device and the speed of the sound depended on the speed with which the person wound the device by means of this crank.

Its ideal place we could say that it is the living room or the living room, where placed on a side table, will give the room an air of elegance and sophistication difficult to match by other decorative items. In our online store you have several models to choose from: with trumpet in gold or silver, with square or octagonal base, in dark or light tones, etc.. Of course, it is worth remembering that although they work and are able to play slate records (in fact, all models include a sample disc), their function is mainly decorative, since their sound quality is obviously much inferior to that of current music playback devices.

How were vinyl records used?

The first 45 rpm records were made of vinyl or polystyrene. Both records used narrow grooves, intended to play audio with a smaller needle, sometimes even referred to as microgrooves.

What is the name of the vinyl record player?

The turntable is also known as turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables, turntables and turntables.

What is a 78 rpm record?

The simple definition: parts that were used in gramophones, the forerunners of vinyl. They are thick, spin at 78 revolutions per minute (rpm) and are made of a composite of various materials, such as rubber, resin, celluloid, slate or layers of paper.

Read more  Are Christmas records worth anything?

Valuable acetate discs

But by 1888, another new improvement came with Emile Berliner, who patented the gramophone, which worked with a 5″ diameter vulcanized rubber disc, and could be copied from the zinc master, which was coated with wax, with a manually driven machine.

The music industry began with the founding of the Columbia Phonograph Company, which in turn replaced the evolving Volta Graphophone Company, which had become The American Graphopone Company.

Boy, did the history of vinyl records have to evolve long before it became what we remember. One of the first steps was the company founded by Emile Berliner and Eldridge Johnson, who improved the gramophone by adding a spring motor to drive the platter.

Enrico Caruso, Italian tenor, was the first singer in history to record a vinyl record, in 1902, his record “Vesti la Giubba” boomed in sales and he was known as the most important artist of his time.

Emile Berliner and Eldridge Johnson consolidated their position at the top of the music scene in 1910, when records and their reproduction and practicality surpassed Edison’s cylinders, thus initiating the history of records.